Thursday, June 18, 2009

Incubating Temperatures

Just got back from Publix's incubator and hatchery. You may not have known they were in the business. They may not know it either.

But, they are. Out front of the store, high off the sidewalk, and back under the cover of the built-in brick awning, is the big, internally lighted sign announcing Publix. I've walked past there for years, and I've made mental notes of the birds chirping from above, and more than once thought about the fact that they were building nests in the sign.

Today, I stopped and looked up, instead of hurrying by. I could see the straw hanging from every nook and cranny, and many parent birds hopping around, probably turning eggs or trying to feed chicks. Near the entry to the store was a propane tank cage, about five feet cubed, and on top, I saw the carcass of a small chick that had fallen from its nest. It didn't survive, of course.

Back when I was still in the business, I got many calls from frustrated growers, wondering why their chicks didn't hatch, and if they did, why they didn't survive. Most of them just wanted some hint of an idea of what may have gone wrong, and while there are many things that affect hatches, the biggest problem, according to research at a leading NC university, is humidity...mostly high humidity.

As I stood there watching the birds flutter about, I decided to come home and write this little post. I almost always had test hatches running at work. Mostly I would be testing a new turner design, a new fan, a new heat element, and often just different humidity settings. I did find, that if I were to err, I would want to do it to the low side. I found temperature could vary a bit without great loss. Hatch day would change, but I'd still get an acceptable hatch rate.

I remember running some test in one of the small tabletop incubators, and I got everything set up so I wouldn't have to come in over the weekend. I don't remember what I was testing, but Monday morning when I got to work and checked the incubator, I found I had left it unplugged. Turner, too.

Well, I still got better than a 50% hatch. That was 48 hours with no turning, and a temperature of about 70 degrees once the incubator cooled down to room temp. Needless to say I was a bit annoyed at myself, because even though there was a hatch, whatever test I had been running had to be started again. But what the hey...what's three more weeks, right?

While I'm on the subject, (this will always be the subject, as a matter of fact) cleanliness comes to mind. We always promote a clean operation. And, I'm sure you do, too. But, I had some interesting calls in that area. I remember one in particular.

It was during the ostrich/emu craze, when everyone was trying to get ahead of the pack. They always hatch with very low humidity and the customer was looking for ways to get his lower. But, that was only part of the reason he called. His neighbor across the street was hatching the same eggs. Trouble is, the neighbor was getting much better hatches. And, it wasn't so much the fact his hatches were better, as it was the competition's methodology.

It seems my caller tried to do everything by the book, even wearing cotton gloves when handling his eggs...just to avoid the oily fingerprints getting on the shell. According to him, his neighbor was dirty, didn't clean his incubators or hatchers, and in general, didn't pay a lot of attention to much of anything. Yet, he got apparently good hatches. But I imagine it's rare. We still maintain a clean operation is a better operation. But, if you're going to miss the humidity level, miss to the low side.

Good hatches to you.

No comments:

Post a Comment